Hello guys,
just wanted to follow this up. The 3 way valve was replaced and seems like it is working now. Thank you so much!
Also, another question came up, is there a way to adjust the setpoint tolerances? The following is happening, not sure if it is how the reefer is supposed to work or not:
I set the temp to lets say 24F, unit cools down to 24F and it shuts down (totally fine) but the temp keeps going down until it reaches 20F then the unit turns on and starts heating to keep the temp in 24F, it reaches 34 – 35F and starts cooling down again.
With this, the unit runs almost all the time without shutting down, not sure if the operational tolerances can be adjusted to open them up a little bit (+\- 8 F maybe?)
Any input is really appreciated.
